I'll select another film then go back to the. Everything else seems to be fine but when I hop over to the subtitles tab and move any existing subtitles from the left window to the right one, they don't stay there. But for some odd reason, when I only select the two front channels, the resulting stereo file combines all the 6 channels into two channels (oh, and I'd like to precise it's not specific to that one 5.1 audio file I'm using. Converting a few videos in XMedia Recode (basically just trying to shrink down some films that are larger than I need them to be). I've tried every other combination (Left front channel and center channel, Left rear channel and LFE channel, etc.), and everytime, the resulting stereo file does only contain the two channels I selected. Try this soft, remuxing should take few seconds only and subtitles will be untouched. The problem is they are swapped and this is what I would like to avoid. You can also use BOX4 to simply remux MKV to MP4, it supports PGS subtitles (is in description) but if your Apple TV supports it dont know. See picture below), I do get a stereo audio file with only the left and right front channels. The funny thing I noticed is that if I swap the channels (basically attributing channel 1 to channel 2 and channel 2 to channel 1. Now, the thing is, technically, the various channels are as follow:īut the problem I encounter is that when I attribute channel 1 (left front channel) to channel 1 and channel 2 (right front channel) to channel 2 in the channel order mode (see picture above), the resulting audio file is a stereo file that combines ALL the channels of the 5.1 file, and not just the left and right front channels. 3.3.7.4) to do some channel mapping, more specifically I'd like to create a stereo file using only the left and right front channels of a 5.1 audio track. I'd like to keep the most recent XMR versions as I want the up-to-date FFMPEG that comes with them.Ĭurious if other XMR user's "Volume Correction" filter is now always enabled as a default or if it a switch that I've missed.So, I'm trying to use XMedia Recode (ver. It always returned in the "enabled" state on re-launch. "Right-Click" and remove the filter entirely. A full uninstall (including all obvious references to XMR in the registry) and then a re-install of the current version.ģ. All versions prior to the last two updates - and the filter is "disabled" as expected on those.Ģ. 3545 and previous), the filter is "disabled" as expected upon re-launch of XMR:ġ. This is now what a re-launch of XMR looks like after having disabled the filter at last use previously:Īfter testing previous versions (ver. Having this filter "enabled" unexpectedly will cause an audio recode with a gain difference that is unwanted. 3551 & 3552) whenever I launch XMR, it is back on again and I have to "disable" manually every time even though I "disabled" at last use. However, since the last two updates (ver. The next time I launched XMR, it was disabled as desired. Once finished, I "right-click" on the "Volume Correction" filter again and "Disable" for the next time (I don't want to leave it on as it's only required sparingly). (I then analyse and "normalize" to the default of 89 db then run my recode). I "right-click" and then choose "enable" to turn it on. Occasionally I will adjust a video's gain/volume using the "Filters/Preview - Audio Track - Volume Correction" filter. Experienced this problem since the last two XMR updates (ver.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |